To make print paste
2 - 4 Tablespoons of Gum Tragacanth depending on the consistency you desire. For painting I use 2 T. for printing I use 4 T 1000 ml of boiling water
Container to boil water in, and heat source for boilingwater
Blender
Squeegee or rubber spatula – the kind used for scraping bowls
Container with screw on lid – 1 quart variety
Respirator for handling the Gum Tragacanth in powdered form
Measuring cups and measuring spoons
Bring 1000 ml of water to a boil add to blender – after
I let it cool a bit so as to not wreck my blender.
Add 2 – 4 Tablespoons of Gum Tragacanth powder to the blender, put lid on blender and blend until a creamy consistency.
Remove from blender using a spatula or squeegee
place into your container with lid. I use wide mouth jars as this makes removing the paste much easier.
Cool the paste to room temperature, cover with tight fitting lid.
Store in refrigerator for up to ten days, I have found that it’ll last longer if you avoid introducing contaminants
to the paste.
2 - 4 Tablespoons of Gum Tragacanth depending on the consistency you desire. For painting I use 2 T. for printing I use 4 T 1000 ml of boiling water
Container to boil water in, and heat source for boilingwater
Blender
Squeegee or rubber spatula – the kind used for scraping bowls
Container with screw on lid – 1 quart variety
Respirator for handling the Gum Tragacanth in powdered form
Measuring cups and measuring spoons
Bring 1000 ml of water to a boil add to blender – after
I let it cool a bit so as to not wreck my blender.
Add 2 – 4 Tablespoons of Gum Tragacanth powder to the blender, put lid on blender and blend until a creamy consistency.
Remove from blender using a spatula or squeegee
place into your container with lid. I use wide mouth jars as this makes removing the paste much easier.
Cool the paste to room temperature, cover with tight fitting lid.
Store in refrigerator for up to ten days, I have found that it’ll last longer if you avoid introducing contaminants
to the paste.